Void INFINITE QX 6 Manuál s instrukcemi stáhnout pdf (Strana 15)

ADDING MORE POWER TO YOUR LAYOUT

• Any trains (including lighted passenger cars) that you run on your layout

require power to operate. The more trains you run, the more power your lay-

out will need. As your layout grows, you may need to add additional power to

meet you power needs.

• The Commander is capable of supplying 2.5 amps of power continuously,

and will shut down if the power exceeds 3.0 amps. You can, however, add up

to three additional power stations to you Commander to supply additional

power.

• To add additional power to you layout, you must first divide your layout

into separate electrical blocks called power districts. Each power station then

supplies power to one or two districts.

• All power stations are connected to the Commander via terminals C & D.

The Commander then sends a low power DCC signal to each of the power

stations, which amplifies that signal and applies it to each of their

power districts.

• For more information on this or any other Atlas Master DCC product, see

our web site www.atlasrr.com

• Note:

The Atlas Generator is not a power station and should not be connect-

ed to terminals C & D. Doing so may damage the Commander and void your

warranty. (See back cover for warranty information)

NOTES

1 2 ... 10 11 12 13 14 15 16

Žádné komentáře

Void INFINITE QX 6 Manuál s instrukcemi Strana 15